www.
Hot
Hot
Hot
Hot
Toner
.com.au info@hottoner.com.au
COPYRIGHT AUGUST 2005. Originated and distributed by Initial.c Technology PTY LTD
WARNING reproduction in whole or in part is an infringement of Copyright.
Refill & Reset Instruction for EPSON C1100 Series
1. Insert the screwdriver into the
cartridge window to unlock the
cartridge. Slightly turn the top
part of the cartridge until you can
see the refill hole. (See picture
below)
2. All the remaining toner in the
cartridge has to be pulled out from
the refill hole before refill. (The
hole pointed by screw driver).
3. Empty any carrier-toner left on
the waste hopper bin by pulling
them out from the waster hole.
(The hole on the right of the refill
hole) If the waste tank is full, the
print will
4.Refill the toner into the cartridge
(see picture above).
P.S: If you find the nozzle that goes on
the end of the bottle is too large to fit
into the hole on the toner cartridge,
making a paper funnel and put inside
the nozzle to narrow the nozzle.
5. The chip on the cartridge
pointed by the screw driver will
not block you printer. Printer may
still report low toner after refill;
however this will not effect your
printing at all time.
Note:
If the Epson C1100 printer does not
recognize the refilled cartridge, follow
these steps:
1) Restart the printer by turning it off for
2-3 minutes, then turning it back on
2) After the printer has restarted, take
out the cartridge and shake it and
reinstall it
3) If these steps don’t work, try
removing waste toner from the waste
hopper. The reason for this is because if
the machine sees too much toner in the
waste hopper, it may think the cartridge
is empty.
