7
CLICK HERE TO GO THE INDEX
© All rights reserved, Easy Group, LLC. Version 2.0
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identification purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.
Brother LC51
Cut the label at joint between the top and bottom halves of the cartridge case.
1.
Flip open the cartridge casing (shell).
2.
Remove the cartridge from the casing (shell).
3.
There is a round hole (well) in the top of the cartridge. Inside the hole or well is
4.
a rubber stopper. Use a thumb drill and drill through the rubber stopper.
Note
: Do not bump or press the “pressure release button”.
Attach the needle onto the syringe and fill the syringe with 10 ml of ink.
5.
Insert the needle through the drilled stopper hole and into the cartridge body.
6.
Please be sure the needle does not press up against the bag or puncture it, as
this will ruin the cartridge and make it unusable.
Very slowly inject the 10ml of ink into the cartridge bag. If ink starts to come
7.
out of the filling hole, stop, as the cartridge is now full (pull back 1ml of ink
from the cartridge back into the syringe to insure that the cartirdge is not over-
filled). Unused ink can be returned to the bottle.
Remove the syringe with needle from the cartridge and seal the hole using the
8.
green tape dots provided or electrical tape. Make sure the hole is sealed airtight.
Place the cartridge back into its casing (shell) and use a piece of tape to hold
9.
the two sides of the casing (shell) together.
Re-install the cartridge back into the printer and run 1 to 3 cleaning cycles as
10.
per printer instructions.
1.
3.
2.
