Home New Arrivals! Company Info Publications Special Features Contact Us
Overview
Required Tools
Required Supplies
Prepare Work Area
Disassembly
Remove the OPC Drum
Cleaning the DebrisCavity
Cleaning the Toner Supply Housing
Re-assemble the Toner Supply Chamber, OPC
Drum and Debris Cavity
Clean the Printer Transfer Corona Wire Assembly
Trouble Shooting
Test Prints
Recommended Supplies
Fuji-Xerox XP-15/20 Toner Cartridges
DOC-0219
O
VERVIEW
These instructions cover the recharging of the Fuji-Xerox XP-15/20 toner cartridge used in the Compaq PageMarq series, the
Dataproducts LZR-1500 series, and other printers using the Fuji Xerox XP-15/20 Laser Engine. These printers print on 11x17"
paper, and have a resolution of 800 x 400 Dpi. Since the paper used in these machines is wider than “normal” 8 1/2 x 11"
cartridges (SX Etc.), this cartridge is also wider (by about 4 inches). If 8 1/2 x 11" paper is used, you will notice that the paper is
ejected from the printer sideways. Keep this in mind when examining test prints because marks that would normally be in a
vertical pattern, will now be horizontal.
The purpose of this disassembly procedure is to vacuum out toner that will have spilled inside the cartridge during shipping and/
or rough handling, to clean the debris cavity, and to clean and fill the supply chamber with new toner. This disassembly
procedure should also be used to examine the internal parts of the cartridge for possible damage, or wear should the printing of
the cartridge be poor and not correctable by any other means.
NOTE: These Instructions should be read completely before proceeding with the recharge.
In order to properly recharge this cartridge you must obtain
the following three items from your customer.
A) 1- XP-15/20 Toner cartridge
B) 1- Printer Transfer Corona Assembly
C) 1- Felt wand
R
EQUIRED
T
OOLS
Phillips head screw driver.
Small Common Screwdriver
Pin Pulling Pliers 3
5 Watt Pen type soldering iron (Optional)
Toner approved vacuum
Needle Nose Pliers Razor Blade
R
EQUIRED
S
UPPLIES
