OKIDATA C3400
A.
B.
D.
F.
C.
REQUIRED FOR A SUCCESSFUL REFILL:
? Toner (Uni-kit for Okidata C3400/C5100/C9000)
? 1 funnel cap
? 1 replacement chip
? 1 flat-head screwdriver
Note: Please read carefully before refilling cartridge.
General Refilling Procedures:
Using the flat-head screwdriver, press gently on the tab as shown in picture A to release
the end-cap and turn (the end-cap) clockwise so that the tab arrives to the second slot
as seen in picture B (some remaining or excess toner can and may fall out of the car-
tridge).
Before opening the bottle of toner, turn it upside down and tap it on a table to loosen the
toner and allow it to flow freely. Remove the cap and pull the seal off the bottle.
Attach the funnel cap or use a 5mm straw, by making proper adjustments to the bottle
cap, to fill the cartridge with toner. If you find it difficult to refill with the funnel cap,
you can create another funnel with newspaper or printing paper to help lead the toner
into the small opening of the toner hopper. Picture C shows the cartridge being refilled
with the 5mm straw. Do not over refill the cartridge, the C3400 can be refilled up to
2 times with the Okidata C5100 universal toner kit and up to 4 times with the Okidata
C9000 universal toner kit. Once you have finished refilling the cartridge, work your
way backwards thru step A and B to close the toner hopper opening.
After you are finished refilling replace the chip as shown in picture D and F.
