Samsung CLP300
REQUIRED FOR A SUCCESSFUL REFILL:
? Toner (Uni-kit for SAMSUNG CLP300)
? 1 hole making tool
? 1 replacement chip
Note: Please read carefully before refilling cartridge.
General Refilling Procedures:
Make sure you hold this cartridge in an upright position before creating a
refill hole (some remaining or excess toner can and may fall out of the car-
tridge). Illustration A on the right shows you where to create a refill hole for
your cartridge. Once the hole has been created, empty any toner left inside the
cartridge (mixing two different brands of toners could result in bad printing,
or rare discoloration in your prints).
Before opening the bottle of toner, turn it upside down and tap it on a table to
loosen the toner and allow it to flow freely. Remove the cap and pull the seal
off the bottle. Attach the funnel cap making to sure it is on tightly. Tilt the
cartridge at a 45 degree angle and then the funnel cap toward the filling hole
and insert it into the hole. If the toner stops flowing before the cartridge is full,
simply remove the toner, close the cap, turn the bottle upside down and tap it
on a table. When you are done refilling this cartridge, simply use duct tape,
or electrical tape to seal the refilling hole back up. Please use illustration B
as a guidance.
Next, you will need to replace the chip. Please follow the diagram to the right
for chip installation instructions. Once you have finished installing the chip,
you may now place your cartridge back into the printer
A.
B.
Do NOT attempt to remove the OEM chip as it is fused
into the cartridge. We will simply place the ultra-thin
replacement chip over the original.
Peel off the strip (shown) to expose the adhesive
backing on the reverse side of the chip.
Apply the new chip over the OEM as shown.
