Hewlett Packard® 8100 Cartridge Remanufacturing Instructions…
HP® 8100
Cartridge
Remanufacturing Instructions
Reference Information: Approximate Remanufacturing
OEM PN: C4182X
Time: 35-40 minutes
OEM Yield: 20,000
@ 5% image area
Recommended Tools: Materials Needed:
Phillips-head screwdriver Oasis PCR cleaner # 99MS21
Small, flat-head screwdriver Clean, lint-free cloth #99CL14
Small diameter punch and 99% Isopropyl Alcohol
Hammer
Hewlett Packard® 8100 Cartridge
Separating the cartridge halves:
1. Use a small, flat head screwdriver to gently pry up the base of the cartridge
clips (located on each side of the cartridge (fig. 1)).
a. Remove the clips by prying outward after they have been lifted (fig. 2).
b. Use a punch to drive the pins into the cartridge (fig. 3). It might be
difficult if they have never been punc hed in before. Note: There are
blockers which prevent the pins from being pushed in easily. The
longer pin is located on the drive gear side.
Figure 1
c. Separate the cartridge halves: toner hopper unit and OPC drum unit.
Figure 2
Figure 3
Toner Hopper Unit Instructions
1. On the toner hopper disassembly: remove the two screws holding the end cap
in place (fig. 4).
Figure 4
Oasis Imaging Products, Inc. Technical Support: (888) 627-6555
Index
