1
Provided by Raven’s Research and Development Department
Ken Myers, Director
Tony Ferraro, Development Chemist
Refill Instructions for
Minolta
®
DiALTA
®
Di151
Konica
®
7415
Lanier
®
5415
NEC
®
Nefax 805
Cartridge Yield: 7,000 pages (@6% coverage) as stated by manufacturer (Minolta
®
)
Materials required:
300 grams of toner
(
specifically designed for this Minolta
®
Di151 application
)
Flat head screwdriver
Phillips Head screwdriver
Pliers
Cotton Swabs, with one wooden end and cotton swab on opposite end
Lint free cloth or tissues
Vacuum cleaner, designed for toner/developer applications
Clean gloves
This all in one cartridge contains the toner and a photoreceptor. In these instructions, you must first separate the developer
housing from the photoreceptor.
1. Prepare a clean work area. Use clean gloves. Remove two screws on each side of the cartridge.
2. On the gear side of the cartridge, lift the upper half of the unit to separate the photoreceptor from the developer housing.
Holding the developer housing, remove the toner plug. Dump and vacuum out any excess toner remaining inside housing.
3. Next, you must remove the developer roller. To begin, remove both springs attached to the seal. Set springs aside. Rotate
shaft retainer on each side of roller. This unlocks the shaft that holds the developer roller. Pull the shaft retainer out.
The gear
and shaft of the development roller are greased. Make sure that this grease does not get onto roller!
Use a lint free towel or tissue
to remove and wipe grease off of shaft and gear at each end of the roller. Carefully lift developer roller out using a lint free cloth.
Place roller on a dry and clean surface.
Raven Industries,Inc.
Center Drive, RD6 Box18A,Latrobe, PA 15650 USA
Tel: 724 539 8230 Fax: 724 539 2264
email: raven@ravenindustries.com http: www.ravenindustries.com
